All looks correct except the govenor arm resting on the crankcase. Bend it back out a bit.
[Linked Image]

The govenor arm might need adjusting. It might have been bumped on the shaft and now does not have the correct range of movement.


Was the cable that way previous??? Thats a sharp bend, I'm surprised it even moves.
Usually the cable goes in the other way.
You can flip it up at the throttle control on the bar so it does what it says.

Move the controler to the other side and run the cable in that way and it will not have to bend so sharply. To keep the mount holes you could just flip the handle over if its a plain one.


Sideways motor is a bit strange.