Ok..

well I completely replaced all the components on my Greenfield 34 fast cut..Started with new chain, sprocket, new shaft and 2x new outer drive plates and new belt.

I followed the instructions to the letter, placing one shim on each side. I replaced the cork a while ago and they seemed ok..

I have now pulled the thing to pieces 4 times and still have same results.

Lots of noice when reversing and the [Censored] thing is then hard to stop when it locks in reverse.

Forwards is a bit better but also still sticking sometimes stuck so tight the belt slips and smokes comes from front pully..

when idling the drive plates are freely spinning.

what to do? advice please..many thanks[Linked Image][Linked Image]

Attached Images
20221031_084741.jpg (87.03 KB, 40 downloads)
20221031_084729.jpg (94.65 KB, 33 downloads)
Last edited by dontknowitall; 31/10/22 08:08 AM.