Likely to be a simple answer, but would like to get feedback if possible.
I have this mower, ran fine, then started running poorly (seeking), then wouldn't run continuously. Thinking it's probably just blocked fuel, I took the carby apart, cleaned it up good, blew compressed air through holes in carby, inspected seals/gaskets etc.. all looked good, no issues (engines fairly new, minimal use). Also blew compressed air through air filter. Air filter doesn't look too bad.
Put back together, starts, runs, but still seems to seek/pulsing. Not only that, on full throttle, it doesn't feel like it's running that fast (can't remember if it was doing this before though)
Questions;
1. Before I pull apart again, is there anything else that would cause the engine to seek/pulse besides poor airflow and/or poor fuel flow ?
2. What would cause the low revving, and is there a way to increase rpm ?
