Hi, My friend is looking for a glow plug for his 4 WD mini tractor. It's a 9 volt glow plug It's a 27 hp 4wd tractor.
Bolens 2704 [G274} / Iseki TE4270/F S. tractor. Glow plug is marked JKC 4F 9V Part number from book is1870256 and 6581-410-0610-0
I went to Wilsons who were pleased to help, their input was.... Thread is 10x1.25. [measured with thread gauge] Diameter of thread is 9.55 mm. [measured with vernier]
I just thought someone might know something about this , hope it's not too off topic.... cheers speedy
Last edited by speedy; 07/09/1804:53 PM.
........................Keep your blades sharp......................
G'day Speedy, That part number corresponds to a M16x1.5 thread glow plug, according to every online listing I can find. The pic looks like 16mm, too. The voltage rating is a bit of an oddball, so finding an aftermarket replacement is likely to be difficult.
Hi speedy Sounds like you're busy as... The bench looks good. I got on to the bundy dealer for Iseki, he was very helpful, they can get me one in for $75, I might have to bite the bullet. Second hand looks a big ask. Fired up the whipper snipper, it seems fine, will use it on the lighter growth. Need rain. Cheers, Chris. ------------------------------------------------------------------------ Thanks Gadge
........................Keep your blades sharp......................
My take on this is, it's not worth spending a lot of time chasing all over the planet, to find a cheapo aftermarket part, of probably dubious quality.
A [admittedly tightfisted] bloke I know insisted on fitting a set of cheapo replacement glow plugs in his HZJ75 series Landcruiser. Didn't end well - one of the things dropped its end into a cylinder, and did significant damage...
Cheers, Gadge
"ODK Mods can explain it to you, but they can't understand it for you..."
"Crazy can be medicated, ignorance can be educated - but there is no cure for stupid..."
