I was given a 38 model edger, and am replacing the blades. How are they meant to go on? They have nylock nuts should these be done up tights with the blades poking out in line with the holder or should they be at a slight angle or 90 degrees to the holder?
Hi Ray078, and a warm welcome to the forum. It's great to have another Scott Bonnar owner on board. Never having owned one of these machines, I have not seen how the blades attach, but the following illustration I have found of a Model 38 gives some detail....they are contra-rotating swing back blades...
Hoping this helps,
Please do not PM me asking for support. Please post your questions in the appropriate forums, as the replies it may receive may help all members, not just the individual member. Kindest Regards, Darryl
I was given a 38 model edger, and am replacing the blades. How are they meant to go on? They have nylock nuts should these be done up tights with the blades poking out in line with the holder or should they be at a slight angle or 90 degrees to the holder?