I was after a bit of help and advice with this carburettor that I have, It's off a 2 hp B&S engine that had not been run for a long time.
The fuel tank has been cleaned out (Was full of old fuel) and the pick up tube was blocked with crud, as you can see in the photos I have the needle out and giving everything a really good clean.
I did manage to get the engine running on Brake clean but not on fuel yet. I wanted to know if there is anything else I need to do after cleaning and new Gaskets etc for it to start pulling fuel up from the tank.
I've seen that video that carb I think is a later version and has a rubber diaphram that is the fuel pump. The one I have doesn't have that, I'm going to see how I go after I finish cleaning everything and reassemble it back together.