Thanks everyone, appreciate the welcome. As I said previously I would like to get machine up and running with a view to a full resto at some point, but she will need a fair bit of panel beating to get it straight again! So to what extent do I need to go to in regards to inspection and replacement of parts so I don't wreck it? I've seen advice on other posts regarding checks for stress fractures on the rails, but is this less likely on the smaller ones? I figure one of the front cogs attached to the cutting cylinder looks pretty thrashed, the one attached to chain that goes to the roller friction plate. The engine goes alright, not too much smoke and relatively smooth for something that's been sitting round for a while so I probably won't go too hard on that to star with more the cutting and running gear. Is there a thread that talks about general maintenenance and tolerances/ tensions so you guys don't have to repeat what I'm sure you have already said before? Again thanks all for replies and guidance and suggestions.
Last edited by EricIsBananaman; 17/05/17 04:34 AM.
