Originally Posted by Bruce
Originally Posted by Derrick_in_Melb
Bruce:

When i try to change the blazes the lawn mower was completely cold.

Sorry i am just making sure i am doing it right.
1. Add unleaded fuel to the lawn mower....is that what you mean when you said "Then put some fuel into the cylinder to wash out it out"???
2. Remove the Spark Plug
3. Starter Rope MUST be in "stop" position
4. Pull it for at least 6 times
5. Replace Spark Plug
6. Run the it again till there is no more smoke???

Is the above points look right to you???

Cheers smile
Derrick
No follow this.

Move step 2 to 1

1. Remove the Spark Plug

2. Add fuel into the cylinder through spark plug hole.

3. Throttle control should be in stop position before you pull the rope.

Then go on with step four through to six. cheers2

Bruce, with step 2 do you mean add fuel into the cylinder of the spark plug, if so how much??? till it drip out???
Below is the pic i just add with an arrow making sure i am doing it right again...
[Linked Image from i22.photobucket.com]