Need help?


Search OutdoorKing-Forum by entering Key Words Below



Who's Online Now
3 members (Steve_2012, Red Rum, AVB), 10,107 guests, and 570 robots.
Key: Admin, Global Mod, Mod
Online Spare Parts


Online Store


Newest Topics
Victa special electronic ignition
by niggz - 09/09/25 10:09 AM
FREE - Victa PowerTorque Mowers
by Polybus - 09/09/25 08:40 AM
McCulloch Mowcart 66
by mm-mowers - 06/09/25 01:20 PM
McCulloch Mowcart 66 service manual
by mm-mowers - 05/09/25 05:03 PM
Loncin 452cc (19hp?) some help is required
by Steve_2012 - 05/09/25 03:15 PM
Victa Magneto to suit early Rotomo 5A
by xsancanin - 02/09/25 08:42 PM
SEVEN Victa Utilities
by Polybus - 01/09/25 10:23 AM
Topic Replies
Loncin 452cc (19hp?) some help is required
by Steve_2012 - 12/09/25 07:36 AM
FREE - Victa PowerTorque Mowers
by Polybus - 10/09/25 08:03 PM
Victa special electronic ignition
by Bruce - 09/09/25 06:08 PM
McCulloch Mowcart 66
by Bruce - 06/09/25 06:33 PM
McCulloch Mowcart 66 service manual
by mm-mowers - 05/09/25 05:03 PM
1971 Victas Self Propelled plus Corvettes
by Polybus - 04/09/25 04:02 PM
More Cox Cone Help
by swamprat96 - 03/09/25 12:56 PM
SEVEN Victa Utilities
by Polybus - 03/09/25 11:11 AM
Victa Magneto to suit early Rotomo 5A
by xsancanin - 02/09/25 08:42 PM
Peerless 820 transaxle
by maxwestern - 01/09/25 06:28 PM
Previous Thread
Next Thread
Print Thread
Rate Thread
Hop To
Page 1 of 2 1 2
#48765 22/08/13 03:25 PM
Joined: May 2012
Posts: 467
Qualified Junior
***
Hey all got this fine machine from a work mate , attempted to start and found muffler was blocked with wasp nest aha ... cleared the blockage and and gave it a mixture tune and it runs sweet as , very tidy for age wheels better than new.

[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]

Joined: Jun 2011
Posts: 4,291
Likes: 4
Master Technician
***
Well who's a lucky bugger now?Good score doesn't look like it's had a lot of use.Well done. party


Here for a good time,not a long time.
Joined: May 2012
Posts: 467
Qualified Junior
***
hey jeffrey , thought you would chime in !
very very little work i think all i need to do is replace the air cleaner foam and change the oil then a fine tune . even has the catcher
think ill remove the engine and clean down then repaint the cowl starter and filter housing

Joined: Jun 2011
Posts: 4,291
Likes: 4
Master Technician
***
I still haven't decided if I wanted to collect those ones yet. If I was to I'd hope that I could find some in the same condition as that one. Is that one around the 1980's?


Here for a good time,not a long time.
Joined: May 2012
Posts: 467
Qualified Junior
***
Hey at a guess late 70's early 80's ill get the engine number tonight
it will tell. all

Joined: Jun 2011
Posts: 4,291
Likes: 4
Master Technician
***
Cool as don't have any paper work on them but I'm fairly sure that were early 80's and run along side the 2 stroke mustang. Which was the first model after the VC-Mustang. I think.


Here for a good time,not a long time.
Joined: Jun 2013
Posts: 78
Likes: 3
Trainee
Tommo


Great score, the base also looks great no splits

I took ownership of an impala, that is identical to the one pictured. Is mine a mustang or an impala what's the difference.


Joined: May 2012
Posts: 467
Qualified Junior
***
hey there !
very tidy base is almost perfect .
there were 3 that i can think of mustang 4 , corvette 4, impala 4, monaro 4
think the only difference with the impala is that they used a air filter on the handles and the snorkle tube.
and the usual colour change
share some pic's on yours ?
cheers tomo

Joined: Jun 2011
Posts: 4,291
Likes: 4
Master Technician
***
Did you forget to check the year? I believe there was only small different's between them. The biggest differance was the name. Some had name plates that was near the carby.


Here for a good time,not a long time.
Joined: May 2012
Posts: 467
Qualified Junior
***
Hey jeffrey sorry was flat out yesterday i
will tonight smile

Joined: May 2012
Posts: 467
Qualified Junior
***
hey , engine numbers -

[Linked Image]
[Linked Image]

Joined: Jun 2011
Posts: 4,291
Likes: 4
Master Technician
***
Well that looks like a 1980 model to me.I thought it was from around that time frame.I just wasn't sure.Here is some codes of things I found on it.
[Linked Image]
That proves that it has the right cowl and the right victacode sticker as well.Good work in finding that gem tomo.Just remember to enjoy it,if not send it to me and it can sit with the rest of the Mustangs here,and I can enjoy it.


Here for a good time,not a long time.
Joined: May 2012
Posts: 467
Qualified Junior
***
hey Jeffrey thanks for sharing the paperwork , really like this one nice and original ,
noticed last night that im going to have to put a new bottom seal in it. got the drips.
hope Agro Mick shares his impala now.
i think if you were to collect them id collect them as a series.
also sure they brought out sabre 4 stroke with a 92908 on the steel base.

Joined: Jun 2013
Posts: 78
Likes: 3
Trainee
Here is my impala



You will note the carb has a snorkel but the base is covered in oil and soot where the exhaust exits against the base.

This girl was received from roadside rubbish. I got I home put fuel in it and it started first pull. However the yard was promptly filled with smoke. I checked the oil level and that was low. I'm guessing someone lost the air leaner cover and element and has run it for years without the filter. The engine has no knocks so I would assume that the engine would only need some new rings to stop its pollution problem.

Honestly I only wanted the base which doesn't have one nick out of it, for my vs sport with the g4 carby.
Does anyone want to change my mind?
[Linked Image]
[Linked Image]
[Linked Image]

Joined: May 2012
Posts: 467
Qualified Junior
***
nice machine man i would put a set of rings in it .
you will find that the engine mounts are a lot larger and a victa 2 stroke wont be compatible
thanks for the pics looks in good shape ... i may have a set of rings for it here

Joined: Jan 2013
Posts: 956
Likes: 20
Moderator
Yes tomo, they definitely made a sabre, white 4 stroke on a green steel deck. I sold it last week so unfortunately no photos.

J
Joe Carroll
Unregistered
They made so many names on them its very hard to keep up with them....

I have two impalas, one is good and in dry storage (thanks Grumpy) the other is quite sad and hadnt been started since the early 90's but it is smoky as hell.

A corvette, never tried to start it, in good nic in dry storage

Two monaros, one is smoky but runs well, the other is in near mint condition and I have never started it - dry storage.

A silver streak, very smoky, was involved in last years floods.

A special treak - very rare I sold my first one without thinking, have never got my hands on more than a engine for a second one.

Thats to name a few, I have a lot of them though and will probably never get to finish them all, im part way through selling/parting out some of my collection as at the moment a thumping great v8 crammed in a medium sized family sedan is taking more of my interest and is costing a lot.

Joined: Jun 2013
Posts: 78
Likes: 3
Trainee
Tomo

Nooo way, I can't use this base with a two stroke? You may have just wrecked my week and its Monday.

What to do what to do? At least my two stroke catcher fits this base.


Joined: May 2012
Posts: 467
Qualified Junior
***
Certainly wont take a 2 stroke sorry man

J
Joe Carroll
Unregistered
You could most likely get a powertorque on there, but definately wont get a older full crank on there...

Page 1 of 2 1 2

Moderated by  Bruce, Gadge 

Link Copied to Clipboard
Forum Donation
These Outdoorking Forums have helped Thousands of people in finding answers to their equipment questions.

If you have received help, please consider making a donation to support the on-going running cost of these forums.

September
M T W T F S S
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30
ShoutChat
Comment Guidelines: Do post respectful and insightful comments. Don't flame, hate, spam.
Newest Members
Flano, mattyj, Markp88, Fearless Prophet, Deejos90
17,577 Registered Users
Forum Statistics
Forums145
Topics12,992
Posts106,835
Members17,577
Most Online14,275
Yesterday at 08:44 PM
OutdoorKing Showcase
20 Bucks from FB Marketplace
20 Bucks from FB Marketplace
by Return Rider, February 20
Victa Cortina 2 Shed Find
Victa Cortina 2 Shed Find
by Return Rider, January 25
My Rover Baron 45
My Rover Baron 45
by Maxwell_Rover_Baron, April 16
SHOWCASE - Precision Mowers - 2021
SHOWCASE - Precision Mowers - 2021
by CyberJack, April 14
SHOWCASE – Atco Rotary – Paul C - 2020
HOME |CONTACT US
Powered by UBB.threads™ PHP Forum Software 8.0.0
(Release build 20240826)
Responsive Width:

PHP: 8.3.24 Page Time: 0.052s Queries: 56 (0.042s) Memory: 0.7262 MB (Peak: 0.8438 MB) Data Comp: Zlib Server Time: 2025-09-11 22:10:10 UTC
Valid HTML 5 and Valid CSS