ARCHIVE: Scott Bonnar Model 40 Catcher Mounts

Would be very grateful if anyone with a Scott Bonnar Model 40 catcher with original catcher, could post a pic of the catcher's mounting plate, where it slots into frame. I have a catcher but previous tenants "improvements" give me little too work off, so that I can have new "original" mounting brackets made.

My catcher is good but sure that SB did not send unit from factory with gal bolts with square nuts as the mounting points for the slots in the frame body.

Last edited by CyberJack; 12/02/16 08:11 AM. Reason: Topic Heading

Re: ARCHIVE: Scott Bonnar Model 40 Catcher Mounts

Cam #39363 28/08/12 06:15 PM

Joined: Jan 2008

Posts: 42

Adelaide

willingworker Offline

Novice

These photos show the connectors on a Scott Bonnar Model 40 catcher which fit into the slots on the side plates. After a lot of use they often needed strengthening and repair.
Regards,
Grant.

Re: ARCHIVE: Scott Bonnar Model 40 Catcher Mounts

willingworker #39365 28/08/12 07:19 PM

Joined: Jul 2005

Posts: 6,362

Likes: 11

Wagga Wagga NSW Australia

Deejay

Administrator - Master Technician

Thanks Grant, once again mate, you have saved the day....Cam will be a happy chappy...

Please do not PM me asking for support. Please post your questions in the appropriate forums, as the replies it may receive may help all members, not just the individual member.
Kindest Regards, Darryl

Re: ARCHIVE: Scott Bonnar Model 40 Catcher Mounts

willingworker #39369 28/08/12 09:58 PM

Joined: Aug 2012

Posts: 10

God's Own/ Perth WA

Cam

Novice

Thank You very much Grant.

It is greatly appreciated!

Perhaps my brother wont receive catcher on Fathers Day but wont be too far off in future.

Grant you are a legend. I could never have guessed that the brackets looked like that from my mangled remnants.

Thanks again,

Cam