OutdoorKing Repair Forum Forums Repairs and Maintenance Questions On Ride On Mowers Questions On Victa Ride On Mower Frames Victa 5/26 Pulley configuration

Hi all,
Looking for a little help. I was given this Victa 5/26 and when the clutch is released one belt is tightening and one belt is loosening. I have attached a picture of the pulley config which I think is wrong if any one is able to confirm as a new motor was put on and wither the pulleys were put on the shafts wrong or something is missing like a idle pulley.

The loose belt that is hanging down goes to the cutting deck and that comes directly off the motor. The pulley on the left back of the picture comes off the gearbox and the front pulley is the sliding pulley attached to the clutch.

Thank you for your help

Hello Wildfire.

I can't personally help, but here are some resources that may assist:

https://www.outdoorking-forum.com.au/forum/ubbthreads.php?ubb=showflat&Number=8332
https://www.outdoorking-forum.com.au/forum/ubbthreads.php?ubb=showflat&Number=20141
https://www.outdoorking-forum.com.au/forum/ubbthreads.php?ubb=showflat&Number=23709

Hope this helps.
------------------------------
Jack

Hi do you have any photos and/or dimensions of the two engine pulleys? I need to know these since mine is missing these, the part numbers dont exist but I can likely get and MTD one if I know the dimensions. Basically the spacing between the two pulleys and the diameters. Thanks

Does anyone know how to remove the main dual pulley from the motor?