i bought a 12.5hp Greenie 30" cut ( I think it is an Evolution 3 DLX) with east west motor and the number plate on top of cowling is missing. I found a number stamped on frame in front right hand corner (35762 - Y). there are a couple of parts missing for the cutting deck adjustment and because they are so hard to get I will have to make them. I will try and post some Photos but because this is my first time on here bear with me please. I need the Lifting arm and Lifting Handle. If there is anyone that has the same model Greenie would they be able to give me the Dimensions of these 2 parts please. Also i need the double engine drive pulley if anyone knows where i can buy them. Any help is much appreciated.
My Greenfield 12.5HP 30"cut Evolution has some parts missing for the Deck Height Adjustment and i need to make them. If anyone has a similar model with same setup would they be able to measure the distance between the holes in part 41 (GT13605 Lifting Handle) and part 46 ( GT13460 Lifting Arm) as shown in attached PDF File.. Should be able to measure these by just lifting bonnet. Any help is much appreciated.
