Hi all,

I just bought an old Greenfield ride on mower in Sydney. Its a 25th anniversary IC11hp. It starts and cutters engage when short, (about 4 inches) lever is shifted into "cu" position,

But when the lever is shifted to the out position the cutters wont disengage. So i turn it off and on startup the cutters are disengaged.

Theres 3 options on the lever.
On the right is OUT.
In the middle is TF
And on the left is CU.
And theres a small chain welded onto the lever with a clip that only allows it to select in TF and OUT.
Doesnt do anything in the tf selection as clip has to be taken off selector to select cu to engage cutter.

Attachments
IMG_20250917_141854[1].jpg (283.79 KB, 21 downloads)
Last edited by syd666; 7 hours ago.