Hello; I have recently repaired this mower with new rings, piston and barrel but now it revs out despite throttle and carburettor working properly. I replaced the seal where the pull starter goes but is there another seal that should be replaced? Also the carburettor is a little cracked (around the edge)but not leaking. Could it be sucking air through there.
You have two other seals. One is on the plastic section that the caby locks onto and the other you will have to take the mount off and it is on the section that goes into the cylinder block.
We have more detailed information under parts list and manuals are.
Regards,
Bruce
Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
Sorry, for the delay in reply. I did not have a seal at the carburretor. I have put one in there but the problem seems to have continued. I think I might have another look at both seals.