|
0 members (),
42
guests, and
81
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
Joined: Dec 2007
Posts: 3
OP
Novice
|
I have a Ryobi Lawn Hornet - Model RLH1100 MK111 with a jammed pull start cord. Can anyone tell me how to remove the clutch rotor assembly to access the recoil pulley assembly?
Hoping you can help Bryan
|
|
|
|
Joined: Dec 1999
Posts: 5,347 Likes: 31
Repair Junkie
|
Bryan, You will need a T20 screw driver to remove the clutch drum as you have a screw in the center of the drum.
Regards, Bruce Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
|
|
|
|
Joined: Dec 2007
Posts: 3
OP
Novice
|
Bruce,
Thank you for your reply. I knew about the screw in the centre of the clutch drum assembly and it has been removed. My problem is how to remove the clutch rotor assembly from the shaft to allow the starter housing to be removed to access the recoil pulley and starter rope. Hope you can assist.
Bryan
|
|
|
|
Joined: Dec 1999
Posts: 5,347 Likes: 31
Repair Junkie
|
Bryan, Ok to remove the the clutch you will need something like a brass dolly and hit the clutch in an anti clockwise direction and it will undo. Then remove the four screws on the housing and you will be into the starter area.
Regards, Bruce Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
|
|
|
|
Joined: Dec 2007
Posts: 3
OP
Novice
|
BRUCE
MANY THANKS FOR YOUR PROMPT ASSISTANCE.
BRYAN
|
|
|
|
Joined: Dec 1999
Posts: 5,347 Likes: 31
Repair Junkie
|
Bryan, Did you get the clutch drum off?
Regards, Bruce Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
|
|
|
M |
T |
W |
T |
F |
S |
S |
|
|
|
|
|
|
1
|
2
|
3
|
4
|
5
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
27
|
28
|
29
|
30
|
|
|
|
|
|
|
|
Forums145
Topics12,750
Posts104,816
Members16,905
|
Most Online2,545 Dec 23rd, 2019
|
|
|
|
|