Need help?


Search OutdoorKing by entering Key Words Below



Who's Online Now
0 members (), 163 guests, and 123 robots.
Key: Admin, Global Mod, Mod
Online Spare Parts


Online Store


Newest Topics
Greenfield Evolution III 10.5
by CJay - 19/07/24 12:34 AM
Villers engine numbers
by Bevan12666! - 17/07/24 06:43 AM
Victa SSA201A Catcher
by PK5 - 11/07/24 05:16 PM
Greenfield Anniversary 88 Idler Sprocket
by Guliyas - 05/07/24 04:55 PM
Looking for service manual Cox Conquest
by MrG6 - 30/06/24 07:11 AM
Mcculloch Super 100 brushcutter
by sirzur - 29/06/24 01:12 PM
Topic Replies
SB45 Resto
by deviosi - 26/07/24 09:30 AM
Greenfield Evolution III 10.5
by NormK - 22/07/24 12:08 PM
Villers engine numbers
by maxwestern - 18/07/24 05:54 PM
Victa SSA201A Catcher
by NormK - 11/07/24 08:39 PM
Greenfield Anniversary 88 Idler Sprocket
by Guliyas - 08/07/24 06:31 AM
HORSE MOWER - Port Melbourne - c1910-1930
by Alan M - 04/07/24 08:43 PM
Looking for service manual Cox Conquest
by MrG6 - 30/06/24 07:11 AM
Mcculloch Super 100 brushcutter
by sirzur - 29/06/24 01:12 PM
Previous Thread
Next Thread
Print Thread
Rate Thread
Hop To
Joined: Nov 2005
Posts: 5
Novice
this mower has started running almost flat out and doesn't respond to throttle control.should I look at removing carby and cleaning as there doesn't seem to be any other adjustments. Have cleaned out tank and tap seems OK, also checked hole in cap.Does anyone have manual for this model with plastic carby. thanks Keith

Joined: Dec 1999
Posts: 5,343
Likes: 30
Repair Junkie
****
Keith,
1. Have you taken the starter off at any time?

2. Have you checked the 'O' ring on the cylinder where the carby mounts?

3. Have you checked the exhaust port for blockage?

Check these first before we go any further.

Regards,

Bruce [Linked Image]


Regards,
[Linked Image]

Bruce


Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
Joined: Nov 2005
Posts: 5
Novice
Thanks Bruce will do, may take a few days. By the way have replaced starter rope and had to dismantle the whole engine and its just broken again. Keith

[This message has been edited by keithburg (edited 13 November 2005).]

Joined: Nov 2005
Posts: 5
Novice
Thanks Bruce will do,may take a few days.Have repaired broken rope by removing half the motor and has just broken again.(Will buy new rope this time) Keith

Joined: Dec 1999
Posts: 5,343
Likes: 30
Repair Junkie
****
keithburg,

Make sure that you replace the 'O' ring when you do the cord replacement.

Regards,

Bruce [Linked Image]


Regards,
[Linked Image]

Bruce


Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
Joined: Nov 2005
Posts: 5
Novice
Thanks once again Bruce, Have replaced starter o ring, carby manifold o ring (after 2 wrong sizes)and motor runs with a little adjustment but still not right. I couldn't remove exhaust, after removing top and bottom clips it was holding pretty tight and thought I might break it.
regards, Keith

Joined: Dec 1999
Posts: 5,343
Likes: 30
Repair Junkie
****
keithburg,

I would suggest getting a new muffler and that would fix your problem. You should be able to get one on e-bay for a good price.

Regards,

Bruce [Linked Image]


Regards,
[Linked Image]

Bruce


Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
Joined: Nov 2005
Posts: 5
Novice
once again Bruce thanks for your invaluable help.
regards Keith


Moderated by  bigted, Bruce, CyberJack, Gadge, Mr Davis 

Link Copied to Clipboard
July
M T W T F S S
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30 31
ShoutChat
Comment Guidelines: Do post respectful and insightful comments. Don't flame, hate, spam.
Newest Members
BigFish1972, LawnLuke, chris s, _s.fletcher_, Waynefury
16,846 Registered Users
Forum Statistics
Forums145
Topics12,730
Posts104,732
Members16,846
Most Online2,545
Dec 23rd, 2019
OutdoorKing Showcase
20 Bucks from FB Marketplace
20 Bucks from FB Marketplace
by Return Rider, February 20
Victa Cortina 2 Shed Find
Victa Cortina 2 Shed Find
by Return Rider, January 25
My Rover Baron 45
My Rover Baron 45
by Maxwell_Rover_Baron, April 16
SHOWCASE - Precision Mowers - 2021
SHOWCASE - Precision Mowers - 2021
by CyberJack, April 14
SHOWCASE – Atco Rotary – Paul C - 2020
SHOWCASE – Atco Rotary – Paul C - 2020
by CyberJack, December 28
HOME |CONTACT US
Powered by UBB.threads™ PHP Forum Software 7.7.5
(Release build 20201027)
Responsive Width:

PHP: 7.4.33 Page Time: 0.132s Queries: 30 (0.114s) Memory: 0.6958 MB (Peak: 0.7475 MB) Data Comp: Zlib Server Time: 2024-07-27 10:35:03 UTC
Valid HTML 5 and Valid CSS