OutdoorKing Repair Forum Forums Repairs and Maintenance Questions on Walk Behind Lawn Mower Frames Victa Lawn Mower Frames HELP with Victa Mustang 18 mower!!!

Hope someone can help here.

1. Cord to start engine snapped so I re-tied what was left of it back up again, but it won't re-coil all the way. Hmmm...why?

2. The plastic primer bulb is leaking whenever I turn ON the fuel. I regret pulling that thing apart now. I read somewhere that there should be some sort of pin/needle, but I couldn't find one when I put it back together. All I got is the floater, a screw and the plastic panel. Please tell me what's amiss.

3.Well the reason I tried (2) above was because when I started the motor, it would run for approx. 30secs and then begin to vibrate quite alot - as if no fuel was being pumped through - and then it would switch off.

Victa Mustang 18 - 2 Stroke - V40 engine pack - Model No.AT047EX08

HELP! Im drowning in my own tears. (sob)

Fible,
The reason for the vibration is either you have throw a blade or part of it off the blade plate. This will cause that problem.

The carby when you have a look at it where the float sits on is a couple of holes and one has a brass seat in it that is where the needle goes.

If you require information e-mail me on support@copepl.com.au and I will forward you information on the carby to assemble it correctly.

Regards,
Bruce

[This message has been edited by Bruce (edited 10-02-2002).]