OutdoorKing Repair Forum Forums Repairs and Maintenance Questions on Chainsaws and Concrete Cutters Petrol Chainsaws and Concrete Cutters Homelite XL-12

Hello
I have an old XL-12 (blue model)there is no UT number,all there is on the tag is

MODEL XL-12
MODEL NO. or SERIAL NO. 41500260

I need to find a sprocket for it,it has 7 teeth and the hole in the middle is 3/4in. then there is a roller bearing with a bushing,bushing measures 5/8in. OD with a 3/8in. hole and looks to be 17/32in.high,bearing is not pressed in and look to be ok,so is bushing
The outside diameter in the bell is 3 1/4in. and the inside is 3 3/32in all measurements done with tape measure as close as I could get
Gear seems to be brazed on and the bell is flat on top and 3/4in high not counting sprocket which is 5/16in. markings on sprocket bell is SS 3/8,any other info you need please post,I really hate to buy a new saw this one runs so nice even though its old
Thank you for any info

[This message has been edited by Pistol_CT (edited 16-05-2004).]

Information has been sent to you so that you can quote part numbers.

Regards,

Bruce