I have acquired a greenfield 12-30 and had no manual for it. I needed to replace the drive belt so I, stupidly, started removing what I thought I needed to to get at the belt. Long story short, I have 3 bits left over when I put it back together again.

I have photos of the 3 parts:

[Linked Image]
[Linked Image]


I assume that the first part is a brace of some sort and I can not ID it on the parts diagram I obtained. The other 2 are listed as "stiffeners' on the chassis parts diagram.

I have looked all over but I can not figure out where the parts go.

Some assistance would be much appreciated.

regards,
Wayne