so - my restoration project has begun after having watched the videos on this site a bunch of times.

I had no trouble removing the handle frames but i was wondering what i should use when cleaning it as it has a bit of rust (its not excessive). Any input re restoring the handle frame much appreciated.

Engine removal - I had no trouble removing the engine except that one half of the clutch is still attached to the engine. I was not too sure how hard i could tap the bolt / screw. see photo below.

[Linked Image]
[Linked Image]
[Linked Image]

Also, I had trouble removing the cutter sprocket nut. I have soaked it in WD40 but Id appreciate any input / ideas as how to remove it.

Lastly - I have taken a couple of photos of all sprockets and Id appreciate your input re the wear of these.

[Linked Image]
[Linked Image]

Last edited by Hooksey; 26/11/14 10:56 AM.