OutdoorKing Repair Forum Forums Repairs and Maintenance Questions on Engines Questions on Other Engines Suzuki 2 stroke rebuilds.

Hi, I have striped down 2 x Suzuki engines and thought I would share a few images.

This engine was dirty inside, but no where near as dirty as the second one.


Might be hard to see but this image shows the cast iron sleeve held in by a spring clip. Because there is no head to remove on these, the carbon is hard to remove, I use a bearing scraper and then a wire wheel on a drill extension.


Crank case halves.


Before I pulled it down, this engine felt better to turn over than the first one.
The bottom seal was completely full of muck. I will put up some images of the bore when I clean it.




To rebuild these, your pretty much just need rings, bearings and seals.

I want to put a remote filter up on the handle, but not sure how to go about it yet.
I also have to source some bearings.