Hi all. I'm new to the forum & so I'm not sure if this specific issue has been discussed before.
I have just given my old Victa 160 commando a spruce up. I never split the motor tho.
I fitted a new plug, a new primer plate & I cleaned & re-furbished the starter motor & fitted new blades and checked the decomp valve is working properly. All basic stuff. I also removed the coil & set the gap to the crank triggers at .005"
My issue is that it doesn't seem to want to rev as high as I'd expect & it also doesn't idle well at all. I'm not familiar with the carburettor on it either. It's a plastic carb. There are two wires running to it which I'm not sure of their purpose either.
Any advice or information would be appreciated.
