Hi guys,

Got a 2 stroke victa tilt-a-cut power edger with S90 engine pack. When I got it I was told not running for awhile. Poured some fresh 2 stroke fuel in it tried to start it after a couple of pulls it tries to start and run. The thing was blowing a lot of white smoke and ran for 10-15 seconds before cutting out.

It's the same story every time you try to start it. Today I took the thing apart to figure out what's going on. The spark plug was clean but has very overpowering petrol smell. When pulling the motor apart there wasn't much of the gaskets left.

This is what the inside's looked like:

[Linked Image]
[Linked Image]

I've cleaned the insides, I'm gonna get a new head gasket, tubes. What else should I be looking at to resolve this problem.




Last edited by Joe Carroll; 27/10/13 06:46 AM.
QSR