Thank you everyone. I was able to pry the bulb out without spliting the case. However, I found that all the fuel line was dry rotted. I did need to take off the left side which was about 8 screws. I could reach everthing I needed from there. The design was pretty straight forward once I got inside. I wasn't sure how far into the fuel tank the return fuel line went so I just left about 1/2" hanging on the inside. I was able to get the parts locally although they were not original replacement parts and 2' of fuel line cost me $4. My total parts expense was about $15. Once again, Thank you for all your help.