Excellent Point Bob
(I could well have fallen into that trap)
I quite understand what you mean,
that could be "not a good look" to have happen!
they only carry two (well 3 ones for brakes)
a small ...no dimensions given at $ 20
(so its a mystery..atm )
and reason for that comment, I was reading the thread on Jono's Honda honing and so assumed that would be the right size
(but have to find and re read the post to be clear on what that said.. oh and I guess a victa 2 stroke bore and honda bore are different beasts being a 4 stroke )
the other they Carry is $60 dimensions are;
2" to 7" (50 to 178mm) with 4" (100mm) medium grit hone stone cylinder
(EDIT it actually sounds like you might have this one Bob, length wise)
I wont post the link thought
4" sound like the length of stone so dont think that would be a problem for the ports oops
Just did a quick rough measurement of the cylinder section
that seems about the length of the bore ? 100mm 4" aprox
so the smaller "if its" 2+~3+ inches somewhere
would I guess be the go...well maybe
but I'll leave that open for comment, advice
just my thinking is 4" dont give you much room to get a cross hatch patten happening evenly
but hey I truly dont have a clue on honing so ..humm open to comment
thanks for the method instruction too
will do
I think the hone is suppose to achieve a 30 degree cross hatch look...from what I read so far too
(with probably the odd deeper scratch here and there I suppose, for me )
Anyway
if the smaller is about 2/3 + of the bore length I guess thats a goer...but maybe 4" is a better option as less chance of uneven hone I guess too..
if you only got to pop out by say half inch each side...
sorry... rambling indecisive thoughts again Bob
Anyway to gather bits and pieces first is next step
...
Thanks again, Bob cheers
Note: to self "special Tools How to"
https://www.outdoorking-forum.com.au/forum/ubbthreads.php?ubb=showflat&Number=33821&gonew=1#UNREADThanks again Bob your a legend
