I'm pulling apart some of my machines to tidy them up a bit. I was looking at some of the parts that bolt on these engines, like throttle cable brackets, engine covers, etc...
I was thinking about dropping them off at my local chrome guy to get a bit of 'bling' happening on these motors.
I'm wondering if I'm going to run in to any major rust issues. I guess if the machines are kept dry, and clean (free of dirt/dust) as much as possible, the chrome bits will stay rust free?
I'd also like to have some of the engine cover/panels and fuel tanks re-powder coated. Probably also the actual carts/frames/chassis of the machines
Looking for anyone that has any experience with this? Just after some advice
