Hi All,

A small update.

I purchased a cheap Compression Tester from Ebay. So I can test it's compression.

With the Decompressor in place , I get 25psi.

Without the Decompressor and the hole plugged, I get 35 psi.

Is these figures correct for a Powertorque Victa 2 stroke lawnmower.

Also I pulled off the Carby and noticed I have quite bit of dirt inside the Carby air intake. It looks looks very dirty from dirt being sucked in. It seems the clamp that goes around the hose and Carby does not Seal enough or it is getting sucked in from the top of the hose.

I am hoping for advice from someone that knows what should the psi of these lawn mowers should be. If it is too low I can pull it all apart and replace the O-rings and Piston Rings.

Thanks
Harry

Last edited by Hazzaman; 15/02/25 11:30 AM.