G'day Mystyler,

Dunno about the Enduro, but Cox Mowers would very likely now have the tooling for the Greenfield push mowers. They were a very good mower - Cyber Jack bought one new!

Whereas I'll never buy a new push mower. Not with 'wood duck' owners who chuck away quality mowers that only need a little fettling - which I'm perfectly capable of, and am set up to do.

I made up a 'mower workbench' top from a few bits of timber and some plywood, that clamps on top of my small 'open grid' welding table. Fabbed up the welding table too, from a scrounged 13mm square bar steel grate, and 3 water pipe legs.

Edit: On reflection, I just might do a couple of my 'how-to' articles on these 'builds' - with a wee bit of encouragement from my ODK audience?

Last edited by Gadge; 13/06/20 09:57 PM. Reason: Teaser...
Cheers,
Gadge

"ODK Mods can explain it to you, but they can't understand it for you..."

"Crazy can be medicated, ignorance can be educated - but there is no cure for stupid..."