Bruce, Can you email a parts list/diagram for a McCulloch chainsaw model 6000383-16? Phillip
Quote
<font face="verdana,arial,helvetica" size="2">Originally posted by Bruce: I can supply a wide variety of spare parts for McCulloch Chainsaws & Brushcutters. Just post your request here.
I am looking for bar tightening stud for a McCulloch Eager Beaver 14" chain saw.
Quote
<font face="verdana,arial,helvetica" size="2">Originally posted by Bruce: I can supply a wide variety of spare parts for McCulloch Chainsaws & Brushcutters. Just post your request here.
Hi Bruce, I have a ProMac 10-10S chainsaw, which has a collapsed big-end bearing. The remains of the outer race has (as expected) damaged the lower edge of the cylinder, which is resisting the removal of the piston (at least without excessive force). The piston is scored, as viewed through the port, as will be the cylinder bore. Other than this failure and the exhaust bolts having fallen out, it is in good condition. Would this be economical to repair? Are over-sized pistons available? And if so, what would be the cost, and range of diameters available? Thank you.
<font face="verdana,arial,helvetica" size="2">Originally posted by Bruce: I can supply a wide variety of spare parts for McCulloch Chainsaws & Brushcutters. Just post your request here.
Regards, Bruce </font>
Bruce, do you have part for a McCulloch blowers Model mc320 bv. Regards Budget
[This message has been edited by Budget (edited 25-08-2004).]
[This message has been edited by Budget (edited 25-08-2004).]
jack41tx, The last time I bought a chain oiler in was 2001. The part number is 219991 that you require but it is expensive. I will have to see if I can get my hands on another one.
Regards,
Bruce
Regards,
Bruce
Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
G'day Bruce, I have a late 70's or early 80's Promac 850 which I believe is a genuine USA model before sell out. It has served me very well for over 20years and still goes like the clappers, but I have not been able to find a manual or parts locally. Can you help? regards - Davo
Hello Bruce, I need the complete clutch assembley for the McCulloc MiniMac 30. The numbers I can find on it are - Model/serial: 600093 A13-9329. I hope you are able to help.
Are you able to supply whole carburettor for Mac 3818 chainsaw 11-600038-29. It's either Zama c1q-m36, Walbro wt-774, Zama c1q-m36, c1q-m33. All are interchangeable. Regards Kev .