Hi fellas, pls see the pic. In the middle of pulling my SB 17 inch apart to have it sprayed. Is there any secret to separating the sprocket/clutch plate from the clutch adjusting bracket/?? It seems well secured. I dont want to start with some gentle persuasion from a hammer just yet.
Below is a picture of the parts list regarding the clutch that will fill you in on how it is assembled. This will help with the removal because if you have removed the centre bolt (which you appear to have done) then the sprocket should slide off without to much trouble providing you have removed the roll pin.
Last edited by Bruce; 13/09/1005:59 AM. Reason: Correct description
Regards,
Bruce
Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
Since this post is over 12 months old, I will now close it.
Please do not PM me asking for support. Please post your questions in the appropriate forums, as the replies it may receive may help all members, not just the individual member. Kindest Regards, Darryl
![[Linked Image]](https://www.outdoorking-forum.com.au/forum/images/members/mower-monsterw.jpg)
