Just found a rubber sealing washer for the clutch output shaft bearing housing, in case you don't have one the dimensions are 35mm OD, 22mm ID and around 2mm thick ( my previous post was incorrect).

I have never seen them but my understanding is that some 20" models use a different cylinder bearing ,I forgot to mention that.

BB, you do what you think is best, hopefully all the info is correct and is of use. Regarding the clutch land roll assy I listed both bearings.

Gino

Last edited by Bonnar_Bloke; 10/03/17 10:51 PM. Reason: Corrected the original Post