Hi Guys,
I recently picked up a non running MCA201G and have been doing a complete teardown and rebuild (a bit of a side project).
It's in very good condition, but it seems like the previous owner tried to play around with the carb and has cracked a little bit off the edge of the carb where the end cap fits on. So the diaphram isn't sealing properly and there is an air leak.
I tried to seal the leak using some Loctite RTV gasket, but the issue seems to be caused by the diaphram not being seated properly.
So.... I was hoping that someone had a good condition body lying around that wasn't going to kill the overall cost of the rebuild.
Any advice is also welcome.
Cheers,
Mark
