Hi GrassQueen1,
Your model is actually the same as a Homelite F2020 model. The way to wind it is:
*Remove bump knob and spool.
*On the spool, you will see two arrows marked 1 and 2. Follow those arrows and you will see holes on the inside of the spool.
*Cut about 1.5m of nylon line, then cut in half (so you end up with two equal lengths approx 75cm long)
*Insert one end of one of the seperate nylon lines into hole number 1, then rotate onto spool the same direction as the arrow shows. when near end of nylon, lock into one of the little slots in the spool so you can let it go!
*repeat procedure for hole number two, and finish your nylon opposite the first one.
*insert the nylon through the outer spools outlet holes and reassemble. Pull cord through the holes so they come out of the locking slots and you are set!
