OutdoorKing Repair Forum Forums Restoring, Customising and Modifying Reel-Type Mowers SB 45 Full Restore - Rookie

Hi all,

I'm now officially the proud owner of an SB45! I picked the mower up this afternoon and have already taken a few photos to upload. The label on the chassis says it is a Model 45 No. 18993. I'm not sure if this actually means anything to anyone but there is a photo of it below as well.

I've tried to get a few good photos of the cylinder. The gentleman I bought it off said it should have around 24mm of meat on the cylinder - does this sound about right? He is happy enough to make the new cylinder and will also replace the bed knife at the same time. What is everyone's opinion on the current cylinder?

The catcher seems to be in OK condition, few dings and a fair bit of surface rust on it. I'm hoping to eventually sand back and sandblast everything and get it powder coated similar to some of the other restorations on it. I don't really want to go too overboard, purely because I will actually use this mower weekly. But a nice fresh coat of paint to the chassis, engine and cylinder and a full clean up of the front roller, new bearings etc. is about all I am after.

I have attached several photos below - I think I managed to get everything that will be required. Let me know if any other photos will help.

Cheers,

Kenny.
















[img]https://www.outdoorking-forum.com.au/forum/uploads/usergals/2014/03/full-7786-15645-20140308_151147.jpg[/img]
[img]https://www.outdoorking-forum.com.au/forum/uploads/usergals/2014/03/full-7786-15646-20140308_151316.jpg[/img]