jamesl,

The settings for the carby are as listed in other posts in this area.

1. Screw in both low & high screws till they bottom.

2. Undo the low screw 1 & 1/4 turns.

3. Undo the high screw 1 turn.

4. Then start the machine and only udjust the low screw until it throttles without much hesitation.

5. The adjust the high screw while the machine is in the high speed position until it peeks then back off 1/8 turn. :Wavey:

If you can't get it to run properly then post again explaining the problem.

Regards,
[Linked Image]

Bruce


Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.