I am having some issues with this engine and its idle. It has sat for a few months so I cleaned the carb out, little bit of gunk main jet was slightly occluded. I cleaned up the fuel tap, tank filter and threw on a new air cleaner. It is a low hour job that I purchased for an engine swap but it has the one inch shaft so that's why the project has taken a while.

It starts and runs with no issues but it idles at 2800rpm by my tachometer. I have taken some pictures of the throttle linkages so that you folk may be able to help.

[Linked Image from i3.photobucket.com]

[Linked Image from i3.photobucket.com]

[Linked Image from i3.photobucket.com]

[Linked Image from i3.photobucket.com]

Any issues with the setup?