I just think you we're cleaning touch as I do it once,mind you I do a big clean. You really don't need to sand if you use a wire bush,as you were saying just have to make sure you don't go to fast. Also never used a heater to hart the job,[Censored] well should have when in Canberra. I only painted in the warmer months down there. I guess that's what happens when your in a hole. You are right should not paint on a wet day or with high humidity. The moisture in the air can affect the paint. I have seen what it does,and it stuffs the whole job. Also the preparation depends on whether you are painting with hammer-tone as it will find a lot of imperfections as it is thicker. If doing it in enamel (or 2 pack) the perpetration is more detailed. Yes I have worked in the panel beating spraying for about 15 years after I left school. I also don't use spray cans as when they are mixed the are mixed at 80% thinners and 20% paint. I get the feeling that your getting upset by some of your comments I'm just trying to show you an easier way. That cleaning 2 or 3 times really is a bit much. If you are unsure of with it is clean enough spray some primer on that will soon show if it needs cleaning.
