Here are some more pic's of the clutch assembly. Just to give anyone an idea of how it works.
Where the arrow is near the bearing. That slides when that lever is engaged..
It pushes the pulley into the outer plate.
[Linked Image from i304.photobucket.com]
[Linked Image from i304.photobucket.com]

The problem I have now is the model 45's Clutch lining I have now is a little bigger than my old one. So how should I modify it? I could trim the outside of it but then I would loose clutch face..mmm I could cut across it in four ways that might work.. Any idea before I chop away.

One of the machinests at work cleaned it all up for me. Done a brilliant job!
[Linked Image from i304.photobucket.com]

Old gasket clutch..
[Linked Image from i304.photobucket.com]

New gasket clutch used on the Model 45's

[Linked Image from i304.photobucket.com]