Hello, My LeyPower Brushcutter has the common KT12AD engine. It became impossible to start, so I put a kit through the carbi, it starts instantly and runs great. BUT, it soon runs out of fuel. The temporary fix is to squeeze the primer bulb ever 5 seconds. Its not sucking fuel. There two back-to-back gaskets at the carbi fuel inlet. No instruction as to which goes first. I placed the thin flexible (brown) membrane closest to the carbi and the black stiff paper gasket furthest away from the carbi. Not sure if I got it the right way around? Wondering if this is the problem? If I got it right, then it would seem that perhaps the fuel filter is blocked, though it looked clean, so I did not change it. Any help is appreciated.
