I'm in desperate advice on how to separate the ratchet/wagon wheel from the rear roller.
As you can see from the dirty old pic, I've inherited a slight headache with no/extremely worn bolt heads. I started trying with easy outs and grinding a screwdriver slot in what was left of the bolt to attempt to unscrew them with a flat blade to no avail.
I then ground the bolt heads off and drilled the remaining thread out.
I've tried the following to separate: Soaking the Rear roller in acetone/veggie Oil mix
Map Gas - front roller shaft inserted and Gently/Rough as guts hit on the spokes Little taps with a fine flat blade to create a gap where the Wagon wheel meets the roller.
Please Help, I'm concerned I've run out the patience which will result in me slogging it thus wrecking the roller and cutting my resto journey short.
