Morning all, A friends Aussie PowerTorque had a wrecked conrod bigend bearing. And main bearings as well and scored bore. So I thought I'd use a chinese PowerTorque I had incomplete..... I had to use Aussie PT coil but it would not fit under chinese flywheel with cogs on outer perimeter for electric start. I'd just sway flywheels. Chinese flywheel has no number on it.
I never took flywheel off before, pretty easy. Set coil gap, but there was not a good fit with a bit of a wobble, it might tighten up when I put round steel thing on and baseplate and bottom nut. Aussie flywheel part no. MAO5548A The chinese motor would not run properly....... found out why when I took flywheel off. It has moved and squashed the flat so changing the timing.....
Any ideas, just try it to see if it tightens up... speedy
Last edited by speedy; 20/02/2211:44 AM.
........................Keep your blades sharp......................
