Hi

Hi all,

I did that when I was converting my FC 24 to a PT motor.

The material is a bit thin and I needed to weld some bits on to give me the slots but it worked.

I intended to get something that worked fairly quickly then use that as a pattern to cut out a proper one from 6mm plate
But it worked so well I didn't bother. I did have to brace it a bit later to stop it bending when the belt tension came on.

There seem to be a few different types of FC 24 bases
Some do not have the sliding plate the early ones I think.

I did all this because FCs are hard to find around here
I did get on to a couple later on however.

Jeff

Last edited by jefffrombrisbane; 28/12/20 10:25 PM.