Hello all,
Long time stalker, first time poster. I was gifted a model 33 from my father and have decided to strip it down and give it some much needed attention, including an engine replacement. I've already learnt so much from this amazing community - many thanks!!
I've managed to loosen the nut from the drive shaft, but unsure if the clutch housing is just pressed on or screwed on. Assuming just pressed but wanted to check before using some force.
If pressed, would a gear puller be the best option to remove?
2021-02-13 13.41.01 by
Stuart Bridge, on Flickr
2023-09-23 16.13.58 by
Stuart Bridge, on Flickr
2023-09-23 16.14.09 by
Stuart Bridge, on Flickr
Thanks,
Stu